Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is difference between dc gain and ac gain ?

Status
Not open for further replies.
A

ahmedsaber

Junior Member level 1
Joined
Mar 11, 2013
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Al Jizah, Egypt
Activity points
1,449
Hi Everyone

What is difference between dc gain and ac gain ?


It is said that op amp gain up dc and ac. lets say op amp gain is 10.
Does it mean that an 10mVac fluctuating on a 10Vdc, would output a 100mVac fluctuating on a 100Vdc?
It doesnt sound so logical to have 100Vdc. If it dc gain does not gain up that way, how does it work?
 

It is the same , that is until the Gain * f product (GBW) is reached.

If OA has GBW of 1MHz then gain of 10 is 100kHZ BW.

If usingg +/-10V supply (and has Rail to Rail saturating outputs) , then with a gain of 10, then the max. linear input range is <1V input MAX for either AC or DC or AC+DC
 

Frequently there is a DC component, which the AC signal rides on.

The op amp's internal circuitry can amplify the AC portion only, without changing the DC level.
 

One could also ask the question, what is the difference between a single ended amp and a difference amp ;)

ANS: Nothing much except perhaps common mode rejection. The single ended amp always has a DC reference for differential DC gain.
 

Hi,

DC gain is the amplification (multiplication) of DC input voltage (at an OPAMP)
A = U(out) / U(in); all under DC conditions.

AC gain ist the same as with DC, but you need to know what (AC) frequency.

OPAMP circuits (with feedback = closed loop) that have different gain at different frequencies are called "filters".
For example a receiver for an IR remote control has low DC gain (surrounding light) and high AC gain (high frequency remote control signal).

An OPAMP without feedback (called "open loop") has extremely high DC gain. It is about constant from 0Hz up to some 10 or 100Hz then it decreases with increasing frequency.
This is caused by the internal circuit and can not be avoided.


Klaus
 
  • Like
Reactions: ICYou

    I

    ICYou

    Points: 2
    Helpful Answer Positive Rating
Amps with DC gain will amplify both DC and AC up to the frequency response and output voltage limits of the amplifier.
Thus if you had a 1Vac signal within the bandwidth of the amplifier with a 1Vdc bias and you had an amp with a gain of two, then the output would be a 2Vac signal with a 2Vdc bias.

Amps with AC gain only, ignore any DC bias and only amplify the AC portion of the signal. This can be achieved by coupling the signal through a series capacitor. The capacitor blocks any DC but passes the AC.
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top