Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Which Programmer Suit For NXP P87LPC 764 Microcontroller

Status
Not open for further replies.
M

maxim10373

Advanced Member level 4
Joined
Feb 26, 2010
Messages
115
Helped
1
Reputation
2
Reaction score
2
Trophy points
1,298
Activity points
2,063
Hi,
which is a suitable Programmer for P87LPC764 FD
Is it Possible Programming Parallel Programmer?
I have G 540 Programmer but I am so confusing and
Lost so many CHIPS.
program done with G540 but circuit not working.
I check FLASH MAGIC but, not supporting P87LPC device.
I can,t use any other micro controller because ,only have HEX file
I am very disturbed about my project because no one reply
from NXP,G540 or my software seller.
I tried for simulation on Proteus but, don't have P87LPC simulation module.

have any suggestion

REPLY PLEASE.

Avk
 

P87LPC764 specification seems very clear to me. It supports serial programming, but using a synchronous protocol not RS232, so it can't be programmed by FlashMagic. But it's supported by many universal programmers.
 
FvM said:
P87LPC764 specification seems very clear to me. It supports serial programming, but using a synchronous protocol not RS232, so it can't be programmed by FlashMagic. But it's supported by many universal programmers.
Click to expand...


sir,
I have a universal programmer(G540) supporting NXP P87LPC764.
But,it don't have ISP systom.I confused about this matter.
 

maxim10373 said:
sir,
I have a universal programmer(G540) supporting NXP P87LPC764.
But,it don't have ISP systom.I confused about this matter.
Click to expand...

I notified one thing.The original CHIP has Printed on PHILIPS logo

and Chip which is used NXP printed. i don,t know there is any mistake.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top