Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
just power up it with 3,3V !
but :
Maximum Fosc is lower than with 5V.
Chek BOR value if you use it.
check ADC convertions +Vref =3,3V default value
Maximum internal voltage reference if used
Use of Max3223 instead of Max232 for Uart
all other parameters...depend of your application
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.