Hadrien Rols
Newbie level 3
Hello everyone,
I recently imported a Spice model of a gain block from Avago Technologies () into ADS.
I am trying to perform a DC simulation but ADS returns the following error :
(stdcmds.ael line 208, column 5)
Failed to create netlist:
Port `gnd' in the design `Pierce_lib:msa0686:schematic' is directly connected to ground.
In a desperate attempt to make it work, I tried to remove the GND symbols from the component schematic but the error was still the same.
Any input on the subject is welcome
Thank you in advance.
I recently imported a Spice model of a gain block from Avago Technologies () into ADS.
I am trying to perform a DC simulation but ADS returns the following error :
(stdcmds.ael line 208, column 5)
Failed to create netlist:
Port `gnd' in the design `Pierce_lib:msa0686:schematic' is directly connected to ground.
In a desperate attempt to make it work, I tried to remove the GND symbols from the component schematic but the error was still the same.
Any input on the subject is welcome
Thank you in advance.