Saraa
Member level 1
Hi everyone,
I am working on a project related to WSNs. in my project, I am using MIB520, IRIS motes with MTS400 sensors and TinyOs2.x.
I am interested in the 2-D accel readings which I succeeded in reading them on my terminal.
MTS400 code I am using prints the values of ACCEL_X, ACCEL_Y, temperature, pressure, light, etc ..
I am seeking your help in knowing how to change the sampling rate for MTS400. Readings appear every 2-3 seconds and I need to see results in milliseconds (or lets say how to get 20 - 100 readings each 1 sec).
Can anyone help me with this please. I need to know where shall I change the frequency for adjusting the sampling rate from the code.
Many thanks in advance!
Yours,
Sara
I am working on a project related to WSNs. in my project, I am using MIB520, IRIS motes with MTS400 sensors and TinyOs2.x.
I am interested in the 2-D accel readings which I succeeded in reading them on my terminal.
MTS400 code I am using prints the values of ACCEL_X, ACCEL_Y, temperature, pressure, light, etc ..
I am seeking your help in knowing how to change the sampling rate for MTS400. Readings appear every 2-3 seconds and I need to see results in milliseconds (or lets say how to get 20 - 100 readings each 1 sec).
Can anyone help me with this please. I need to know where shall I change the frequency for adjusting the sampling rate from the code.
Many thanks in advance!
Yours,
Sara
