Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

3 phase motor foot pedal

Status
Not open for further replies.
T

Terry Coyle

Newbie level 1
Joined
Dec 15, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hi
I have a 3 phase motor on a blanking press.
I am looking for a way to install a foot pedal on it for a simple blanking operation.
Simply put press foot pedal and press actuates.

background is all mechanical so any help would be appreciated.

Regards
T
 

Manufacturer should have some options for this. no?
Voltage/ Current rating and arc suppression are some factors to consider as well as de-acceleration time of motors if required. ( Short circuit)
 

You need a foot pedal switch and a three phase magnetic contactor. See the picture below.



What is the voltage system (220V or 110V) at your location ?
What are the motor ratings ? (voltage, current, horse-power or kilowatt etc.)
 

Install on-off switch to 2 HP and smaller single-phase motors. ... single-throw switch in conduit box with switch guard and 6-foot, S.O. type cord; Replace ... Treatment to a 3-phase, TEFC, motor of the mechanical and electrical components.
download (1).jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top