Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
refer to the picture attached, if I add a 6v power,why the Vgs value is 0.001v, but according to the datasheet of BSP149, Vgs threshold is -1.4v at typical and minimun -1v.
I think your SIM program does not know anything about that unusualdepletion mode Mosfet.
The currents are very low maybe because the drain and source are not connected to anything.
The 13V zener diode is not going to do anything in that 6V circuit.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.