Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about Noise and Domestic Wiring to Outlets

Status
Not open for further replies.
E

elektrotechnik

Junior Member level 1
Joined
Jul 31, 2013
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
198
Hi all,

I have a question about home wiring.

1) Are normal homes wired with 120(L-N), 120(L-G), 0(N-G)?
2) In what situations are homes wired with 120(L-N), 60(L-G), 60(N-G)?
3) Would the situation in #2 present any unique situations in regards to noise or signal quality?

Thanks!
 

elektrotechnik said:
Hi all,

I have a question about home wiring.

1) Are normal homes wired with 120(L-N), 120(L-G), 0(N-G)?
2) In what situations are homes wired with 120(L-N), 60(L-G), 60(N-G)?
3) Would the situation in #2 present any unique situations in regards to noise or signal quality?

Thanks!
Click to expand...

No home is wired that way if the electrician/engineer/inspector are doing their jobs.
 

wade_hassler said:
No home is wired that way if the electrician/engineer/inspector are doing their jobs.
Click to expand...

Wired in the way of bullet #2, or in bullet #1?

Can you comment on whether bullet #2 wiring would present any unique signals and/or noise?
 

#2 is sometimes seen in recording studios and such where the somewhat dubious claim is that it reduces capacitively coupled noise.

It poses some unique circuit protection challenges (Double pole breakers and fusing for fire protection), disconnect time and loop impedance being the biggies, and must be treated as a separately derived supply (I think there is something in the NEC on the subject, but this stuff is really the proper domain of the electrical engineer rather then electrician)..

Interestingly most US homes are fed this way anyway, it is hust that the voltage is 240 presented as 120-0-120.

Regards, Dan.
 

THe Distribution transformer uses one centre-tapped phase to supply 240Vac in North America called Line 1, Line 2 and tap is Neutral.

Thus outlets are all L1+N or L2+N with safety ground.
Thus every 2nd breaker taps L1 or L2 and goes throughout the home. Electric Stoves get L1+L2 for main oven heaters and only use L+ N for stove top to eliminate need for double pole relays, fuses etc.

Although L1 is 180 deg out of phase with L2, they are still called Single Phase as it is derived from 1 of 3 phases with a centre tap out.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top