Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

digital isolator and RS422

Status
Not open for further replies.

kunal5959

Junior Member level 3
Joined
Jul 26, 2011
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,644
I have to isolate a Microcontroller atmega128 having serial interface MAX1481 from another Atmega circuit using ADum4402 full duplex isolator. Can anyone guide me in designing the schematic for such an isolation. The schematic below gives a brief idea showing atmega128 connected via RXD and txd to MAX1481 (rs422 transciever) and the chip adum4402 digi isolator is also present..Please guide me with the circuit design so the signals sent or received by Microcontroller is exac replica of signal on other side of adum4402. adum.jpg
 

The isolator must be connected on the logic side of the RS422 transceiver.
 

Yes i understand but what about the terminating resisitors or capacitors?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top