Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] problems with TIP 122 as switching transistor.

Status
Not open for further replies.
B

boiler95

Member level 1
Joined
Jan 7, 2011
Messages
38
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,731
Hi,

I'm trying to control a LED panel using a PIC micro-controller PIC16F72. I have configured RB4 on PORTB as O/P. Please find the circuit diagram attached.
My LED panel consists of approx 30 Rows of led, all rows in parallel.
Each row has 3 LED in series
Only 1 row has 2 LED's

When i send a high on the output port all the LED glows. When i send a low on the O/p Port all are off except the row with 2 LEDs which glow slightly. When i measure voltage across the panel it measure ~5.4 V.


These LEDs have a Fwd voltage of around 3.2-3.4V and Forward current of 20mA.

I don't want those LEDs to Glow and need all LEDs to be completely off when the o/p of the micro-controller is low.

can someone please let me know.

Thanks

 

Hi,

And if you put an extra led, of the same type, on to that column with 2 leds to make 3 leds, it works ok ?
 

I assume you also have current limiting resistors in each chain of LEDS.
Try connecting a resistor (~ 15K) between the base and emitter. The TIP122 is a darlington with quite high leakage current which could be enough to light the LEDS.

Brian.
 
betwixt said:
I assume you also have current limiting resistors in each chain of LEDS.
Try connecting a resistor (~ 15K) between the base and emitter. The TIP122 is a darlington with quite high leakage current which could be enough to light the LEDS.

Brian.
Click to expand...

Thank you, that worked !!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top