Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

H-Bridge Driver With N-Channel MOSFETs/IGBT

Status
Not open for further replies.
M

mcmsat13

Member level 5
Joined
Apr 24, 2013
Messages
94
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Activity points
2,287
I hope this circuit is ok for uMOS/IGBT H-bridge driver. My device is dual IGBT.
IR2110 H-Bridge Drive.png

I will be using it to drive 24V and 48V power Inverter.

Mitsubishi_igbt_modules.jpgIGBT Module Symbol - Dual.jpg

Please if the Cap for the bootstrap is under/over-ratted, I want to be corrected

Thanks.
 

Bootstrap capacitors have to be chosen according to maximum pulse width.

For low voltage applications, MOSFETs are usually preferred due to lower saturation voltage.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top