Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to montage a through hole PC Board Connector

Status
Not open for further replies.
M

moreho

Member level 1
Joined
Dec 8, 2008
Messages
41
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
1,561
Last edited by a moderator:

These connectors are intended to be soldered to regular through-plated holes, I presume the manufacturers provide typical footprint layouts.

I don't see how the previous threads are related to your question.
 
  • Like
Reactions: moreho

    M

    moreho

    Points: 2
    Helpful Answer Positive Rating
You can solder from reverse side of the PCB(or laminate ).Thru hole plating will be soldered and your connector will be tied to line.
 
  • Like
Reactions: moreho

    M

    moreho

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top