Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ART2 kit applied to AR9344

Status
Not open for further replies.
F

fengzujian

Newbie level 5
Joined
May 27, 2006
Messages
10
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,384
I'm not a developer of Embedded system. My project is use AR9344 to setup a system in long haul clock convey purpose. I already have ART2 kit in hand, I want to make sure whether I could use USB device mode to config a Board based on AR9344(not fully comply to the DB120). Because there is no Ethernet port or PCIE port available.
I use a NAND flash to boot the chip. For the customized usage, it is 5GHz single direction communication.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top