Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about differential amplifier resistor

Status
Not open for further replies.
This two resistors forming a local common mode fedback setting constant gate potential for M0 and M1.
The better AC performance is obtained by setting R value below 1/gm0 - this moving pole bounded with cgs of M0, M1 in higher frequencies.
 

hi,
Dominik has explained the function of those resistors, you may also find this LTSpice sim of your circuit interesting.

The maximum signal amplitudes occur at the maximum resistor values.

E
 

Attachments

  • AAesp01.gif
    AAesp01.gif
    51.2 KB · Views: 70

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top