Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[PIC] Temperature and Humidity Indicator

Status
Not open for further replies.

vnsbudhe

Newbie
Joined
Aug 9, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
I am a new learner.

I have built temperature and Humidity indicator using PIC 16F877a (LM35 +SH20).

I Have following two problems.

1) If I program to read only Temperature or only Humidity it shows correct.
But when I select Temperature + Humidity - Both shows erratic reading ( RA1 and RA2).
Request to suggest solution.
2) When I am reading Temperature it hunts 27 - 27.5 - 29 - 27.5 etc - How to make it stable

Thanks

Vijay
 

I don't know what SH20 is. SHT20 is a digital sensor with I2C interface. In so far it's not clear how you connected the sensor. Please clarify, preferably show a schematic.
 

Post your code. Mention which Compiler and what crystal frequency you are using.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top