Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to drive 10 bit LVDS lcd with 8 bit LVDS tv board

Status
Not open for further replies.

-=[-=[

Newbie level 1
Joined
Jun 11, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,293
Hi experts,

My Sharp LC-37GX3W stopped to work, and according to the error code, something is wrong in the main board.
I decided to throw out the whole panel and install the universal (v59) tv board. (no service manual available at all).
After searching in the internet I found this Sharp has a TCON board with dual channel 10 bit LVDS. (5 differential data line + 1 differential synch line) /channel .
However the universal tv board has dual channel 8 bit LVDS interface.

My idea was, just simple connect the A-A, B-B, C-C, D-D, Synch-synch, and just leave open the "E" line in the TCON board.
Is it possible to make this setup work ?

https://obrazki.elektroda.pl/9057981300_1410502006.jpg
https://obrazki.elektroda.pl/4767548500_1410502007.jpg

Also, I have a problem with the R/L, U/D, MV_MODE,ROMSEL1,ROMSEL0, TEMP1, TEMP2, TEMP3, PE, OS_EN, SHIP_EN terminals of the Sharp TCON connector.

I guess the TEMP1,2,3 should be temperature sensor output, so might be I don't need to connect those. but the other pins...........

I would appreciate any link to the service manual of this TV. Seems it is domestic Japanes product, so the service manual is not easily reachable in the web.

Thanks in advance,
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top