Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[Moved]Smps and uc3842 project

Status
Not open for further replies.

bkar

Junior Member level 3
Joined
Nov 1, 2010
Messages
26
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,626
Dear all,

I am tiring to make a project about SMPS with UC3842 IC. I found a link. please check here.I also found a component for uc3842 of Proteus 8. I draw the same circuit in Proteus 8. But when I run the simulation it does not shows any out put volt.I am attached my project files & screen shot.
1. Screen Shot:
UC3842.png
2. Project Files:
View attachment US3842-45.rar

If possible please help me on this regards. Once again don't mind for my bad English.


BR//
Bahadur Kar
Dhaka, Bangladesh
 

I see there are warnings in your proteus simulation, kindly check it may be you will find some hints.
 

Thank for response. You are right. But I wanted to design SMPS using proteus for understand the simulation. Is there any other way to make a simple SMPS cirute Using proteus?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top