Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

BLDC Motor Driver DRV8312

Status
Not open for further replies.
L

Learning_goal

Newbie level 4
Joined
Mar 23, 2013
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,332
I want to use the DRV8312 motor driver IC by TI for driving a BLDC motor. The motor has encoders attached so I can use proper controls by a uc.
The datasheet says that if I use the motor driver without hall sensors, I need an inductor at the power stage output. Can anyone tell me how to make the circuit and use the motor driver properly.
Thanks
 

Hi,

The datasheet says that if I use the motor driver without hall sensors, I need an inductor at the power stage output.
Click to expand...

i can´t find this information in datasheet.

I currently work with BLDC with and without hall sensors, but afaik the inductor is not related to hall sensors.


For overcurrent protection you can use external inductor.

To calculate the inductance you can see in datasheet:

formula.png
Where Toc_delay = 250 nS, Ipeak = 15 A (below abs max rating).
Click to expand...

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top