Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Plotting E and H field in HFSS (2D Radiation pattern)

Status
Not open for further replies.
V

vijaimvk

Newbie level 5
Joined
Mar 4, 2014
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
59
I am Using HFSS 9.2
This is my 3D radiation pattern
3d radiation.jpg

Hence I expect figure of 8 in XZ plane and circle in XY plane

for x plane i followed the steps as shown in below pictures.

2d1.jpg

2d2.jpg

2d3.jpg

But not getting proper result...

For XZ plane

Changed angle as theta,
Under Sweeps tab selected Phi=0,

If this is wrong ..plz suggest corrections
 

Hi vijaimvk,

I'm not sure what you're trying to do. You can plot 2D plots by selecting Far Fields Report -> Radiation Pattern. You can then plot vs theta or phi, selecting the cut angles with the "families" tab.

Good Luck
 

PlanarMetamaterials said:
Hi vijaimvk,

I'm not sure what you're trying to do. You can plot 2D plots by selecting Far Fields Report -> Radiation Pattern. You can then plot vs theta or phi, selecting the cut angles with the "families" tab.

Good Luck
Click to expand...


As in the above images, there is only 3 tabs.. ..Antenna oriented in the XZ plane ... hence my E plane is xz plane and H plane is xy plane..

hence for XZ plane I set phi=0 deg and theta = all ,and theta as primary sweep .

for XY plane I set theta =90 deg and phi= all, and phi as primary sweep ..

But not getting them correctly ..... plz help
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top