Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

50OHM Striple line question

Status
Not open for further replies.
F

firecow

Newbie level 4
Joined
Jul 6, 2014
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
39
I am using a software to calculate the width of line at 50 Ohm for antenna going into GPS chip.
It is double layer PCB with FR4. Thickness of PCB is 1.6MM. 1oz

The result is 2.9mm width on pcb as attached pic.
13a.jpg

However the pin spcae of this chip is only 1.2MM. how to run this 2.9MM line to antenna pin? 2.9MM is much wider than 1.2mm.
PCB as below. the green arrow point to the line at width 1.2mm only. how can it be 2.9mm for 50Ohm impedance?
14a.jpg
 
Last edited:

I would guess you would run a 1.2mm trace from the pin, calculate its impedance, and then match it to your 50ohm 2.9mm strip.

The question now is, what impedance does your chip want at this pin ?
 

kripacharya said:
I would guess you would run a 1.2mm trace from the pin, calculate its impedance, and then match it to your 50ohm 2.9mm strip.

The question now is, what impedance does your chip want at this pin ?
Click to expand...

It is GPS signal. it should be 50 Ohm.

- - - Updated - - -

PCB as below. the green arrow point to the line at width 1.2mm only. how can it be 2.9mm for 50Ohm impedance?
14a.jpg
 

You see in your screenshot that the effective wavelength was calculated as 102mm.

Transmission line effects are only seen when a line starts to be electrically large. For very short lines, the transmission line effects are very small. Rule of thumb: Line impedance of lines shorter than 1/20 wavelength is not critical at all. So don't worry, no need to have a matched line for this short segment.
 

A > 50 ohms planar strip segment can be calculated as series inductance. It can be compensated if exact impedance matching is required.

Reviewing your PCB detail, it doesn't look like you're trying to achieve 50 ohm impedance for the continuation of the transmission line. In so far, the problem doesn't seem to be particularly related to the pad geometry of the GPS module.

Usually multi-layer and/or thinner PCB substrates will allow to match 50 ohm microstrip impedance from the pad. And even for 1.6 mm double layer, the transmission line can be designed as coplanar strip with ground.
 

thanks so much for all above
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top