haydar
Advanced Member level 4
hfss intersect
Hi
My design is not so straigth, there are some curves(cylinder). I draw a coaxial cable that touches a cylinder, but it gives intersection problem. How can I assure that they touche each other but not intersect? Can subtraction be a solution?
When I zoom the connection, it looks as they are not touching, but error occurs.
Another problem is with radiation boundary. As far as I know, radiation boundary should not contain waveport. Air contains coax and waveport is one end of the coax. What should I do for this problem?
Thanks for help.
Below, snapshot of the design can be seen..
Hi
My design is not so straigth, there are some curves(cylinder). I draw a coaxial cable that touches a cylinder, but it gives intersection problem. How can I assure that they touche each other but not intersect? Can subtraction be a solution?
When I zoom the connection, it looks as they are not touching, but error occurs.
Another problem is with radiation boundary. As far as I know, radiation boundary should not contain waveport. Air contains coax and waveport is one end of the coax. What should I do for this problem?
Thanks for help.
Below, snapshot of the design can be seen..