Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Frequency-dependent impedance boundary in HFSS

Status
Not open for further replies.
elec-eng

elec-eng

Full Member level 5
Joined
Nov 16, 2006
Messages
243
Helped
20
Reputation
40
Reaction score
5
Trophy points
1,298
Activity points
2,927
Frequency-dependent impedance boundary in HFSS and ADS

Dear all,

I want to know how to assign a frequency-dependent "impedance boundary" to a surface in HFSS. I know I can use the variable "Freq" "e.g. Freq^2" while assigning the boundary to the surface, but what I have is tabulated values of the surface impedance Zs stored in a file "Re(Zs) and Im(Zs) vs. freq.", where Zs is the surface impedance calculated elsewhere using more accurate models.

-How to do the same in ADS momentum

Thanks
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top