$herlock
Newbie level 1
I constructed micro-strip PCB inductor (coil ) in ADS 2009 for a particular application,
The setup is a 2 layered system which houses the coil on 1 side and layout for a few IC's on the bottom side. PFA the setup image.
Now the issue arises when i export the layout in the form of a gerber, is that all the circular arcs in the layout ( in the layer colored yellow), including the coil (shown in brown) do not have associated with them DCode values. Hence, i haven't been able to push the design for production. I wanted to know the modifications and enhancements in the design that takes care of these aspects.
Help appreciated.
The setup is a 2 layered system which houses the coil on 1 side and layout for a few IC's on the bottom side. PFA the setup image.
Now the issue arises when i export the layout in the form of a gerber, is that all the circular arcs in the layout ( in the layer colored yellow), including the coil (shown in brown) do not have associated with them DCode values. Hence, i haven't been able to push the design for production. I wanted to know the modifications and enhancements in the design that takes care of these aspects.
Help appreciated.