Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Psrr simulation operational amplifier !

Status
Not open for further replies.
B

biolycans

Member level 2
Joined
Aug 24, 2013
Messages
50
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
478
Hi,

I designed an operational amplifier CMOS two stage. I want to simulate the PSRR. Vdd = 2.5 V and Vss = -2.5 V, are the voltages supply of the opamp.

What configuration and values in the input should I choose for the simulation of the PSRR ?

Regards,

Joaquin
 

You need to do a simple ac simulation with power supply ac=1 and look on the output of closed loop opamp.
 
Dominik Przyborowski said:
You need to do a simple ac simulation with power supply ac=1 and look on the output of closed loop opamp.
Click to expand...

Hi, thank you for your response. I did this:

1) the inverting input is connected to the output.
2) the not inverting input is connected to a offset to balance the opamp. Then I put an AC 1 in serie with Vdd.

the plot has an amplitude of -80 dB and then increase. Is this correct ?

Regards,

JC
 

In fact PSRR=-dB20(VF("/your_output_net"))

For low frequencies PSRR should be high and start decreasing around opamp dominant pole.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top