Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PC ATX psu with +5V remote sense

Status
Not open for further replies.

fjpompeo

Advanced Member level 1
Joined
Nov 29, 2003
Messages
415
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
Brazil
Activity points
3,042
Hi folks,

I need to power a CNC cpu with a PC ATX smps but the TTL based cpu is one meter far from the PSU and the cable's voltage drop is more then 1 volt so need to remote sense +5Vdc output of the PC smps using TL494 IC. Will use only +5V(+-5% TTL LS tolerance) and -/+12V(that can reach -/+15V without problem).

Can you help me?

P.S. There is a lot of electrical noise inside a CNC latch electical panel!

Regards,

Fernando - PU2PLL
 

Here is the schematic of an ATX PSU: http://www.pavouk.comp.cz/hw/en_atxps.html

As you can see there is a feedback path from the +5V and +12v outputs - maybe
you could modify your supply and route them to your load instead. Use shielded
wires.
If the electrical noise level is very high you might need to build a differential
sense circuit of some kind, but you can try this simple modification to start with.

/Rambo
 

Well, can't you use the power cable wire of a gauge wide enough to eliminate this 1 Volt drops over the feeding wires?
You can use some special EMI filters or path-through capacitors to reduce the noise.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top