Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

problem in matlab simulink

Status
Not open for further replies.

mohamed mahmoud

Junior Member level 1
Joined
Jan 31, 2014
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
118
i can,t connect cmos buffer terminal (to or from) any block mat.JPG
what i can do ??
 

Obviously you can't! Pulse generator signal output type is incompatible with CMOS Buffer and D-FF. For the D-FF you can insert a data type conversion block. For the CMOS buffer you have to use sources from the SimElectronics toolbox only.
 

Obviously you can't! Pulse generator signal output type is incompatible with CMOS Buffer and D-FF. For the D-FF you can insert a data type conversion block. For the CMOS buffer you have to use sources from the SimElectronics toolbox only.

HOPEFULLY if you take a snapshot to what you have said
thanks in advance
 

It's clear enough, don't think a snapshot is necessary! Go to simulink library and search for: 1. data type conversion 2. SimElectronics and have a look at the sources.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top