Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Switching the mosfet with PWM completly on/off reduces the power lost to a minimum. Otherwize the mosfet is like a variable resistor and converts the power lost into heat.
using variable resistor is not so efficient way to control the speed of dc motor.energy is wasted in terms of heat.that's why,pwm is used as speed is controlled by duty cycle
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
