Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

printed antenna with omnidirectional pattern

Status
Not open for further replies.

myata

Newbie level 3
Joined
Jan 18, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
25
Hello, I should make planar antenna at 20 GHz with donut RP. It should cover with good gain all 360 in azimuth and at least 90 degrees in elevation. I tried lots of designs of monopole, loop, U-shape antennas with or without ground plane. But they are omnidirectional only when they are electrically small(poor matching), but not in normal resonating size. Monopole array gives me small angle in elevation.
Please give me an advice what can be wrong in my designs or some good examples of omni printed antennas. Probably there are some tricks how to match electrically small antennas.

Thanks in advance:)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top