Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why input amperage mentioned on a device's nameplate but not output amperage ?

Status
Not open for further replies.
M

munzir

Full Member level 6
Joined
Oct 11, 2011
Messages
365
Helped
22
Reputation
44
Reaction score
21
Trophy points
1,298
Location
Pak
Activity points
3,795
Why input amperage mentioned on a device's nameplate but not output amperage ?
 

???
This question is very ambiguous.
Is the "device" a power supply? Or an audio amplifier? or something else?
 

Because before connecting the device to the mains, you should verify that the socket will whinstand the current required by the device.

If the device is a power supply, this is made in low voltage and so it is not so dangerous.

Overall the input power of the device is regulated by international rules, but the output is regulated by nobody ( free choice ).

Mandi
 

On UPS nameplate / specifications ..........
 

FANT said:
Because before connecting the device to the mains, you should verify that the socket will whinstand the current required by the device.

If the device is a power supply, this is made in low voltage and so it is not so dangerous.

Overall the input power of the device is regulated by international rules, but the output is regulated by nobody ( free choice ).

Mandi
Click to expand...

The nameplate amperage is the maximum the device will draw from the power outlet - immaterial of what the output is. Thus if your output socket can supply the nameplate current, you are ok. Your output current will (In the case of a power supply) be (Iin x Vin / Vout) x Efficiency (anywhere between 99% and as low as 45%). As long as you do not grossly overload the device, the nameplate current will be the max that you draw from the supply.
Does this help?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top