Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Characteristic Impedance measurement using network Analyzer

Status
Not open for further replies.
V

VJKris

Member level 1
Joined
Jun 22, 2012
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,530
Hi,

I want to know on how to measure the characteristic impedance of a PCB trace.I know that the same can be measured through a TDR. But is it possible to measure using a network Analyzer?
I can see a feature to plot Smith Chart in the network anlayzer. Can this be used to measure the characteristics impedance Z0 ? Is this a correct method?

Regards,
VJ
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top