Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how 2 perform noise in transient analysis using H-Spice...

Status
Not open for further replies.
P

pnanda65675

Member level 2
Joined
May 24, 2004
Messages
45
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
433
perform noise in transient analysis using H-Spice...how 2 do tat ? can we realise te noise using transient simulation...take a cmmn source single stage as a example !!! i got te Von=4nV/ √ Hz in ac analysis
input reffered noise = output noise/ gain of te bandwidth ?
is tat inp refered noise n equivalent input noise is same ?
sum attachments will b rely helpful....10q
 

Re: how 2 perform noise in transient analysis using H-Spice.

It is possible for simulators which can store a transient point and use this op storage as an operating point for an AC analysis including noise.

I think Spectre and Smash can do this. But I think it is not possible via the ADE for Spectre.
 

do u hav ny articles tat shows te correct way of simulating noise in spectre ??how 2 perform noise figure waveforms?? i tried n cant get a solution..te rest such equivalent inp/out & squared inp/out noise voltg can b simulated n manage 2 get te waveform..except noise figure ?? Thn how abt using H-Spice??do u hav ny idea....
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top