Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Reverse Engineering for an LED Driver

Status
Not open for further replies.
P

Pato2010

Junior Member level 1
Joined
Oct 23, 2013
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
Egypt
Activity points
99
Dear all,
I have a sample of an LED Driver and needs to open it without breaking any part.
attached is the covering picture of the product . It seemed that the cover is a heat sink itself.
I just need a way to open it safely
Thank you,
photo0403.jpgphoto0404.jpg
 

is it sealed with potting compound in the back? doesn't look like a metal plate on the back
 

Potting material can be removed. The hardness of the potting material will decrease if you put it in an oven with 120 deg C. Be careful the wire may burn out.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top