Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

8 Digit SSD using 2 74HC595

Status
Not open for further replies.
you are using six data line you can use only 3 data line this will make simple
 

    V

    Points: 2
    Helpful Answer Positive Rating
Can you explain how? The first 595 is used to send data to the SSD data line and the 2nd 595 is used for turning ON/OFF SSDs.

You mean like this?

If SH_CP and ST_CP, DS are made common then both display data and enable/disable data has to be sent as 16 bits with 595 cascaded. First 8 bits SSD data + 8 bits SSD ON data is sent next time 8 bits SSD data (all 0s) + 8 bits SSD OFF data is sent and finally stored.


Edit: 8 Digit SSD using 3 Wire and 2 74HC595s. File attached.

97846d1382965687-8dssd3w.png
 

Attachments

  • PIC18F452 2 74HC595 3 Wire 8D SSD.rar
    66.9 KB · Views: 98
  • 8dssd3w.png
    8dssd3w.png
    33.2 KB · Views: 132
Last edited:

    V

    Points: 2
    Helpful Answer Positive Rating
yes this is way
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top