Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi first forget about the primary, design a core of known area and material, calculate the maximum flux density.
Now calculate the Ampere turns needed to make it saturate, and test it after winding primary coil..
The bias shd be made by a constant current source, A small core would be better for your application
because it will saturate for a lower Ampere turns..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
