Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

taking too much current or voltage during start up any electronic device

Status
Not open for further replies.

neeraj786

Newbie level 5
Joined
Dec 21, 2011
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,340
When ever we turn on any electronics device it takes too much voltage or current.. after that it leaves it. why???
 

Electronic device if uses SMPS contain capacitors to act as tank for fluctuating voltage ,which act as short circuit during initial power up ,but insted of that now circuits contains MOV,ressatable fuses etc.which comes to normally functioning after attaining certain temperature,this temperature is achieved through power supply current
 
  • Like
Reactions: IanP

    IanP

    Points: 2
    Helpful Answer Positive Rating
what do want to say ???? Exactly ??? i didn't get too much ??
 

Refrigerator had a compressor -----> inside a motor you know well at start up motor requires high current once it achive normal rpm current drops for computer monitor contains CRT which act as a very big capacitor it requires initally very high current (Property of capacitor) and Switched mode power supply common to both .In SMPS the first circuit contains big capacitor which again require large inital current

if you see in broad way inductive device(motor) and capacitor when ever comes in picture you can see this phenomenon but it can't be seen in resistive load ,Check simple bulb it will not show you this
 
When ever we turn on any electronics device it takes too much voltage or current.. after that it leaves it. why???

You can call this effect – inrush current.
In all electronic devices you can find bigger or smaller storage capacitors that, as the name indicates, have to be charged first and that occurs when the power is switched on.
Once caps are charged the device’s current consumption drops to its average value.
:wink:
IanP
 
  • Like
Reactions: vyomax

    vyomax

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top