Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Rotation of parts by arbitary angle in PSPICE

Status
Not open for further replies.
C

chessmath

Newbie level 1
Joined
May 27, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi
I would like to know how I can rotate parts in PSpice by an arbitarly angle for example by 45 degree,I know how to do it by 90, 180, 270 .
Any help will be highly appreciated.

thanks.:razz:
 

I don't think it is possible for parts. Parts are designed in pspice such that their end points are exactly on grids for simplicity. If you rotate them by arbitrary angle it will violate that rule. so it is not possible.
The feature you are asking for can only be used for wires, bus etc.
 

You are talking about Orcad or the old PSpice schematic editor?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top