Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problems in netlist in ISIS Proteus and how to edit part in Schematics

Status
Not open for further replies.
I

Ishah

Member level 1
Joined
Mar 13, 2013
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,502
error 1.JPGerror 2.JPGerror 3.JPG

Hi All,

I am using ISIS for schematic design and ARES for PCB design.
I new of both of it, now Im finished draw my Voltage regulator 12V-5V with NO ERC error found and netlist generate OK. But I got from when I transfer it into ARES as attached.

Is there any way to do this? To connect the netlist accordingly.
Kindly help and guide.


Thanks in Advance.
 

The error message means that the footprint (PCB shape) that you have chosen/assigned for the capacitor
has no/or wrong pin numbers assigned to its pads.

hope this helps
 

babbit12 said:
The error message means that the footprint (PCB shape) that you have chosen/assigned for the capacitor
has no/or wrong pin numbers assigned to its pads.

hope this helps
Click to expand...


Thanks for the reply.

Can you guide me or provides me a link or manual for pin assignment.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top