Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[MOVED] circuit related questions

Status
Not open for further replies.
That's why I asking why the 2 pin need to set to 1?and can u give an example about the offset?
 

for example

you are placing the reflector in 1 m
you are getting i value 100 means it is more than the offset(80) and the output will be some pin high
and if you placed some where else and getting 70 means the output will be different..
 

If 70 output will be?so more than offset or less than is better?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top