Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Why snubber circuit is used at output of a relay switch?

Status
Not open for further replies.
S

shantilal.s50

Junior Member level 1
Joined
Jun 8, 2013
Messages
15
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Location
Jaipur
Activity points
110
I found that a snubber circuit is used at output of a relay switch.
Here snubber circuit as shunt at o/p which is combination of a "Resistor and Capacitor"
 

shantilal.s50 said:
I found that a snubber circuit is used at output of a relay switch.
Here snubber circuit as shunt at o/p which is combination of a "Resistor and Capacitor"
Click to expand...

resistor and capacitor combination is used to quench the spark,it is a spark quenching arrangement,if the same is not used the contact/contacts of a relay may get spark and burn.regards
 

In other words- You can not suddenly interrupt current from inductive circuit, if this the case then you should provide alternate path to current and snubber does precisely the same.
 
The reason why snubber network is placed at the output of a relay is to suppress transient. In other word, it is to protect the circuit from sudden changes in voltage (dV/dt). It is worth noting that the type of transient that the snubber is effectively working against is initiation transient.
Initiation transients are produced when a circuit is originally dead is energized suddenly and very fast (the switching of the relay).
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top