Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When i rout PCB at first i place big elements and make trial rout for understanding how to do this board and problems that can rise. After several trial variants i place resistors, capacitors and other small elements and make full rout to the end.
Once Before we fix the stackup we route signals to analyse the routing flow with some impedance- We call it trail route
After Stack up being fixed, we used to route it exactly based on stack up(impedace)- We call it detail route
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
