Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

My design shows boundaries overlapping error

Status
Not open for further replies.
H

Haris007

Newbie level 2
Joined
May 3, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
I have made the Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards design from IEEE page in hfss. But after designing I have error/warnings which is

[warning] Warning - Boundary 'Rad1' and Boundary 'gnd_plane' overlap.

Also I don't able to get s11 plot according to IEEE plot. How to get same s11 parameter graph.?

Also How to measure vswr from s11 plot in hfss.

IEEE document and HFSS design is also attach. Please help me on this problems.
 

Attachments

  • UWB_21.zip
    663.9 KB · Views: 89

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top