+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Newbie level 2
    Points: 22, Level: 1

    Join Date
    May 2013
    Posts
    2
    Helped
    0 / 0
    Points
    22
    Level
    1

    Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards

    In IEEE document, Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards, I have the problem to made another side which is right side of spline whereas Left hand side is made correctly in HFSS. How to make it?

    Secondly how to made two bottom rectangles which is back side.

    Thirdly, one large rectangle has to be made but I have doubt that either I will draw box or rectangle but hfss shows that rectangle with equal side is not possible.

    PDF file is also attached.

    Please help me for three problem that i have discussed above.

    •   AltAdvertisment

        
       

  2. #2
    Full Member level 4
    Points: 2,236, Level: 10

    Join Date
    Feb 2013
    Posts
    202
    Helped
    170 / 170
    Points
    2,236
    Level
    10

    Re: Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards

    How far exactly have you progressed in your hfss design ? The previous post is not very clear. If you upload your hfss file, I can take a look at it.



--[[ ]]--