Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SOT23-6 Component Marking Code 41FAH help

Status
Not open for further replies.
H

HeleneCT

Newbie level 6
Joined
Apr 30, 2013
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,368
Hi everybody,

I am looking for a SOT23-6 component with Code Marking 41FAH (I'm not sure all of it is the marking code but it's what is written on the top of the package)

Can someone tell me what is this part?

From the rest of my PCB board i'm guessing it's some kind of switch (transistor, mofset? ...)

thanks.
 

SOT-89-5 Under Development.

Code FAH
Part ID RP170N181B


300mA 10V INPUT LDO REGULATOR
LVR-IC LDO, 1.8V±1%, 300mA, +CE SOT-23-5

- - - Updated - - -

I'm not 100% sure but check.
 

Attachments

  • RP170.pdf
    646.8 KB · Views: 53

Don't think this is it, my component has 6 pins.
 

tpetar said:
Check linked datasheet and picture of SOT-89-5.
Click to expand...

I already did that before replying, it's not the right part. Mine has pin 1, 2, 5 and 6 connected together and is most likely used as a switch, that's why I thought it was a MOSFET or a transistor.
I did found something on the NXP website :
PBSS4160V
60 V, 1 A NPN low V CEsat (BISS) transistor

but the marking code is only 41, so I'm not sure because I can't figure what is FAH for in that case, some kind of time stamp?
 

It's ok thanks for yout help.

I didn't notice before but there are some characters that have a libe above them.
I also have identified he type of component it is, is some king of power transistor with the marking : 4/1F/AH with /1 meaning 1 with a line above it.

HeleneCT
 

I finally managed to take a picture. the part is circled in red.

I also draw the part because I couldn't have a close picture.
Dimension (measured with a ruler) :
3mm*1.5mm*1mm

img1.jpgIMG_20130517_112827.jpg


thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top