Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Monte carlo simulations.....saving process parameters using hspice

Status
Not open for further replies.

satishgra

Member level 3
Joined
Mar 29, 2008
Messages
59
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Bangalore
Activity points
1,717
Hi,

I am running monte carlo simulations and wanted to know if there is a way to save all the process parameters values during each iteration.

To be more clear, say I run 10000 samples varying vth, tox & u, I want to save the values of these 3 parameters during every single sample out of 10000

Regards,
Satish
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top