Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

controling the out put voltage of Atmega 8L

Status
Not open for further replies.

angel.angel

Member level 1
Joined
Jan 23, 2013
Messages
36
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
India
Activity points
1,533
hi dear friend.
Here I m getting the O/P of MCU 5V. But I want the O/P 2V. How can I control it by program or any other option..
 

the microcontroller will give output same as what ever the supply voltage is.....but if you want 2V output....then u can use a voltage divider configuration.....and if current requirements are high u can use an opamp as a buffer after voltage divider....
 

Thanks for the information. Actualy I also want to generate the sinosoidal wave using MCU. CAn u tell me how this can be happen.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top