anerDev
Newbie level 3
Hi folks,
I'm using the Sim908 module with an Arduino shield.
But, I don't know why, there is a wrong baudrate setting and the library, of Arduino, say:
but don't work.
1 week ago it worked, now no, with the same sketch. I haven't change the baudrate with AT commands.
So, there is one way for a reset ? Factory reset
Thank you
I'm using the Sim908 module with an Arduino shield.
But, I don't know why, there is a wrong baudrate setting and the library, of Arduino, say:
Trying to force the baud-rate to 9600
but don't work.
1 week ago it worked, now no, with the same sketch. I haven't change the baudrate with AT commands.
So, there is one way for a reset ? Factory reset
Thank you