eeks
Newbie level 3
hello,
just wanted to run something by i case i'm missing something obvious,
i've got a small 24 volt BLDC motor (3 phase) that is fed from an allegro micro driver chip which in turn is fed from a lab power supply.
The power supply is set at 15 volts and the current is 312 mA
but when i use a clamp ammeter on each phase i'm measuring 1 A on each phase
how can this be?
many thanks for any input
just wanted to run something by i case i'm missing something obvious,
i've got a small 24 volt BLDC motor (3 phase) that is fed from an allegro micro driver chip which in turn is fed from a lab power supply.
The power supply is set at 15 volts and the current is 312 mA
but when i use a clamp ammeter on each phase i'm measuring 1 A on each phase
how can this be?
many thanks for any input
