Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] poles and zeros of Two satge folded cascode

Status
Not open for further replies.

vaah

Member level 3
Joined
May 24, 2012
Messages
67
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
US
Activity points
1,785
I'm going to design a two stage folded cascode OTA.
first stage is folded cascode(nmos input pair) to provide gain
second stage is common source to increase the output range
compensation is cascode compensation


My question is in my circuit, how to find poles and zeroes?
It had a compex trasformer Eq. & I couldnt simple it.



Thanks a lot!
 

I am assuming that you are trying to simulate and get the poles. for hand calculations you can look at any book for opamps and it will have the derivations.

you basically tie the op-amp in negative feeback mode with an inductor(1GHenry) so that is in stable DC bias state and the input to the resistor. They you put a ac signal to the positive terminal and frequency sweep and you get the two poles ...


I'm going to design a two stage folded cascode OTA.
first stage is folded cascode(nmos input pair) to provide gain
second stage is common source to increase the output range
compensation is cascode compensation


My question is in my circuit, how to find poles and zeroes?
It had a compex trasformer Eq. & I couldnt simple it.



Thanks a lot!
 

Tnx a lot
But I wanna determine poles/zeros by hand(2 stage folded cascode-sigle ended)
I wasnt able to find it in any book.
Can u tell me what book(s)?

Tnx in advance
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top