Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

JTAG Pin Header Problem

Status
Not open for further replies.

MarcoAndarcia

Newbie level 4
Joined
Oct 31, 2012
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,322
Hi

I I made a footprint for a 14 pin header in order to program my microcontroller. Problem is the diameter of holes on the pcb are 27 milinches (0.6858 mm). I know the standard is 37 milinches. I have been looking for pin headers for 2 days now that met this requirement. The spacing between the pinholes is 0.1 inches. I'm trying to come up with a header that will fit. anybody knows of a pin header I could use?

Thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top