Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

problem with low side of ir2110

Status
Not open for further replies.
C

chotu

Newbie level 2
Joined
Jun 13, 2012
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
hi , i m using ir2110 for my dc motor driver ckt . the problem comes when the input to the lin goes floating , please check if there is any error in the schematic i m providing pwm from a microcontroller at 10 kHz
 

Attachments

  • driver relay ckt.pdf
    12.2 KB · Views: 110

Can you upload the signal wave form from the micro-controller?
 

IR2110 has weak input pull-down resistors, so the input won't actually float. It may be the case, that you are driving it with a pull-up resistor in the microcontroller. In this case, you would want to place a stronger external pull-down.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top